Allied Telesis AT-S63 - Manual (Page 234)

Chapter 11: File Downloads and Uploads
234 Section II: Advanced Operations
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The “2 - Stacking Services” selection is available only on master
switches.
The Stacking Services menu is shown in Figure 17 on page 97.
3. From the Stacking Services menu, type 1 to select Get/Refresh List of
Switches. The master switch polls the subnet for other enhanced
stacking switches in the same enhanced stack and displays the
switches in the Stacking Services menu.
4. Type 5 to select Load Configuration File.
The following prompt is displayed:
Remote switches will reboot after load is complete
Do you want to load the last saved master configuration?
[Yes/No] ->
5. If you want to upload the master switch’s active boot configuration file
onto the other switch, type Y for yes and go to step 7. If you want to
upload a different configuration file from the master switch, type N for
no.
The following prompt is displayed:
Enter the configuration file name ->
6. Enter the name of the configuration file stored in the master switch’s
file system you want to upload. The name must include the suffix
“.cfg”. (To view the names of the configuration files, refer to “Displaying
System Files” on page 212.)
After you have entered a name, the following prompt is displayed:
Enter the list of switches ->
7. Enter the number (Num column in the menu) of the AT-9400 Series
switch where you want to upload the configuration file. You can specify
more than one switch at a time (for example, 2,4,5).
Note
You can upload an AT-9400 Series configuration file only onto other
AT-9400 Series switches. Do not attempt to upload the file onto any
other type of enhanced stacking switch.