Allied Telesis AT-S63 - Manual (Page 369)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 369
DSCP value
The replacement value to write into the DSCP (TOS) field of the
packets.
ToS
Specifies a replacement value to write into the Type of Service (ToS)
field of IPv4 packets. The range is 1 to 7. A ToS value specified at the
policy level is used only if no value has been specified at the flow
group and traffic class levels.
Move ToS to Priority
If set to yes, replaces the value in the 802.1p priority field with the
value in the ToS priority field on IPv4 packets. If set to No, which is the
default, the packets retain their preexisting 802.1p priority level.
Move Priority to ToS
If set to yes, replaces the value in the ToS priority field with the value in
the 802.1p priority field on IPv4 packets. If set to No, which is the
default, the packets retain their preexisting ToS priority level.
Send to Mirror Port
Copies the traffic that meets the criteria of the classifiers to a
destination mirror port. If you set this to yes, you must specify the
destination port by creating a port mirror, as explained in Chapter 9,
“Port Mirroring” on page 185.
Traffic Class List
The traffic classes assigned to the policy.
Redirect Port
The port to which the classified traffic from the ingress port is assigned.
Ingress Port List
The ingress ports where the policy is assigned.
Egress Port
The egress port where the policy is assigned.