Allied Telesis AT-S63 - Manual (Page 81)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 81
IP Address
IP address of the local interface.
Subnet Mask
Subnet mask of the local interface.
Gateway
For AT-9400 Series switches that support IPv4 routing, such as the
AT-9448Ts and AT-9448Ts/XP switches, this field displays the IP
address of the next hop of the switch’s default route. The switch uses
the default route when it receives a network packet for routing, but
cannot find a route for it in the routing table. This field will contain
0.0.0.0 if no default route is defined on the switch.
For AT-9400 Series switches that do not support IPv4 packet routing,
such as the AT-9424T/GB and AT-9424T/SP switches, this field
displays the default gateway address. This is the IP address of a router
interface on your network. The switch’s management software uses
this address as the next hop to reaching a remote network device,
such as a remote management workstation or a syslog server, when
the switch’s local interface and the remote device are on different
subnets. The default value is 0.0.0.0.
Note
For instructions on configuring the routing interfaces on the switch,
including the local interface, refer to Chapter 29, “Internet Protocol
Version 4 Routing Interfaces” on page 697. For background
information on routing interfaces and the Internet Protocol version 4
packet routing feature, refer to the latest version of the AT-S63
Management Software Command Line Interface User’s Guide.
System Up Time
The number of days, hours, minutes, and seconds the switch has been
operational. You cannot change this setting.
Bootloader and Build Date
The version of the bootloader software and the date it was built.
Application and Build Date
The version of the AT-S63 management software that the switch is
currently running and the date it was built.
System Name
The name of the switch.
Administrator
The administrator of the switch.
Location
The location of the switch.