Allied Telesis AT-S63 - Manual (Page 687)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 687
Adding and Deleting Egress Ports
This procedure explains how to add and delete egress ports from the MAC
addresses in a MAC address-based VLAN.
Before adding egress ports to a MAC address, review the following:
ˆ The egress ports of a MAC address-based VLAN are considered as a
community. Assigning a port to one address makes it an egress port
for all the addresses in the same VLAN.
ˆ A MAC address must have at least one egress port. Otherwise, the
address is not considered a part of the VLAN and the PVID of the port
where the packet’s of the node are received determines VLAN
membership.
ˆ A MAC address must be added to a VLAN before you can assign it an
egress port. For instructions, refer to “Adding and Deleting MAC
Addresses” on page 685.
For background information on egress ports in a MAC address-based
VLAN, refer to “Egress Ports” on page 676. To review all the guidelines to
creating and managing this type of VLAN, refer to “Guidelines” on
page 681.
To add or delete egress ports from a MAC address, perform the following
procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 199 on page 602.
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 200 on page 603.
3. From the Configure VLANs menu, type 2 to select Modify VLAN.
The Modify VLAN menu is shown in Figure 202 on page 609.
4. From the Modify VLAN menu, type 3 to select Configure MAC
Associations.
The MAC Based VLANs menu is shown in Figure 231 on page 685.
5. To add an egress port to a MAC address, type 3 to select Add Ports.
To delete an address, type 4 to select Delete Ports.
The following prompt is displayed:
Please enter VLAN ID -> [1 to 4094] -> 2