Allied Telesis AT-S63 - Manual (Page 506)

Chapter 21: SNMPv3
506 Section IV: SNMPv3
3. From the Configure SNMPv3 Community Table, type 3 to select Modify
SNMPv3 Table Entry.
The Modify SNMPv3 Community Table Menu is shown in Figure 156
on page 503.
4. To change the Storage Type, type 4 to select Set Storage Type.
The following prompt is displayed:
Enter Community Index:
5. Enter the Community Index of the Storage Type you want to change.
The following prompt is displayed:
Enter Storage type [V-volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to an entry in the
SNMPv3 Community Table to the configuration file. After making
changes to an SNMP Community Table entry with a Volatile storage
type, the
S - Save Configuration Changes option does not appear on the Main
Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Community Table to the configuration file. After making
changes to an SNMPv3 Community Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears on
the Main Menu, allowing you to save your changes. Allied Telesyn
recommends this storage type.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.