Allied Telesis AT-S63 - Manual (Page 747)

AT-S63 Management Software Menus Interface User’s Guide
Section VIII: Port Security 747
The Configure Authenticator Port Access Parameters menu is shown
in Figure 253.
Figure 253. Configure Authenticator Port Access Parameters Menu
6. Adjust the following parameters as necessary.
0 - Authentication Mode
This parameter can take the following values on an authenticator port:
ˆ 802.1x: Specifies 802.1x username and password authentication.
With this authentication method the supplicant must provide, either
manually or automatically, a username and password. This
authentication method requires 802.1x client software on the
supplicant nodes.
ˆ MAC based: Specifies MAC address-based authentication. The
authenticator port extracts the source MAC address from the initial
frames received from a supplicant and automatically sends the
address as both the username and password of the supplicant to
the authentication server. Supplicant nodes must have 802.1x
client software for this authentication method.
For further information, refer to “Authentication Modes” on page 726.
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Configure Authenticator Port Access Parameters
Configuring Port 3
0 - Authentication Mode ...... 802.1x
1 - Supplicant Mode .......... Single
2 - Port Control ............. Auto
3 - Quiet Period ............. 60 Seconds
4 - TX Period ................ 30 Seconds
5 - Reauth Enabled ........... Enabled
6 - Reauth Period ............ 3600 Seconds
7 - Supplicant Timeout ....... 30 Seconds
8 - Server Timeout ........... 30 Seconds
9 - Max Requests ............. 2
A - VLAN Assignment .......... Enabled
B - Secure VLAN .............. On
C - Control Direction ........ Both
D - Piggyback Mode ........... Disabled
E - Guest VLAN ............... None
R - Return to Previous Menu
Enter your selection?