Allied Telesis AT-S63 - Manual (Page 400)

Chapter 19: MLD Snooping
400 Section III: IGMP Snooping, MLD Snooping, and RRP Snooping
Enabling or Disabling MLD Snooping
To activate or deactivate MLD snooping on the switch, perform the
following procedure:
1. From the Main Menu, type 6 to select Advanced Configuration.
The Advanced Configuration menu is shown in Figure 129 on page
386.
2. From the Advanced Configuration menu, type 3 to select MLD
Snooping Configuration.
The MLD Snooping Configuration menu is shown in Figure 133 on
page 397.
3. From the MLD Snooping Configuration menu, type 1 to select MLD
Snooping Status.
The following prompt is displayed:
MLD Snooping Status (E-Enabled, D-Disabled) :
4. Type E to enable MLD or D to disable it. The default setting is
disabled.
A change to the status of MLD snooping is immediately implemented
on the switch:
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.