Allied Telesis AT-S63 - Manual (Page 231)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 231
VLAN. Furthermore, the interface is designated as the local interface
on the switch.
For example, if the switch has the static IP address 149.44.44.44 and
the management VLAN has a VID of 12, the upgrade process
automatically creates a routing interface with the same IP address and
names it VLAN12-0. It assigns the interface to the VLAN with the VID
of 12 and designates it as the switch’s local interface. For information
on routing interfaces, refer to the latest version of the AT-S63
Management Software Command Line Interface User’s Guide.
To upload the AT-S63 management software image from a master switch
to other switches in the same enhanced stack, perform the following
procedure:
1. From the Main Menu, type 8 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 16 on page 95.
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The “2 - Stacking Services” selection is only available on a master
switch.
The Stacking Services menu is shown in Figure 17 on page 97.
3. From the Stacking Services menu, type 1 to select Get/Refresh List of
Switches. The master switch polls the subnet for other enhanced
stacking switches in the same enhanced stack and displays the
switches in the Stacking Services menu.
4. Type 4 to select Download Image/Bootloader File.
The following prompt is displayed:
Remote switches will reboot after load is complete.
Enter the list of switches ->
5. Enter the number (Num column in the menu) of the AT-9400 Series
switch whose software you want to update. You can specify more than
one switch at a time (for example, 2,4,5).
Note
The AT-S63 software is only supported on AT-9400 Series switches.