Allied Telesis AT-S63 - Manual (Page 32)

Preface
32
History of New Features
This section contains the history of the new features in the AT-S63
management software.
Version 2.0.0
Table 1 lists the new feature in version 2.0.0 of the AT-S63 management
software.
Note
The AT-9408LC ⁄SP, AT-9424T/GB, and AT-9424T/SP switches do
not support the IPv4 packet routing feature. However, these
switches do allow you to create one routing interface as a means of
assigning an IP address to the unit to support those management
functions where an IP address is necessary.
Note
When an AT-9400 Series switch with an IP address is upgraded
from AT-S63 version 1.3.0 or earlier to the latest version, a routing
interface is automatically created on the device to preserve its IP
configuration. The interface is assigned to the same VLAN that
functioned as the switch’s management VLAN. If the switch does not
have an IP address, no routing interface is created. For further
information on routing interfaces, refer to Chapter 32, “Internet
Protocol Version 4 Packet Routing” in the latest version of the
AT-S63 Management Software Command Line Interface User’s
Guide.
Table 1. New Features in AT-S63 Version 2.0.0
Feature Change Chapter
Internet Protocol version
4 packet routing with:
ˆ Routing interfaces
ˆ Static routes
ˆ Router Information
Protocol (RIP)
versions 1 and 2
New feature. Chapter 29, “Internet Protocol
Version 4 Routing Interfaces” on
page 697. The chapter is limited to
routing interfaces because the
menus interface does not support
static routes or RIP. Refer to
Chapter 32, “Internet Protocol
Version 4 Packet Routing” in the
latest version of the AT-S63
Management Software Command
Line Interface User’s Guide for
background information and
commands for all elements of this
new feature.