Allied Telesis AT-S63 - Manual (Page 107)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 107
Enabling or Disabling SNMP Management
To enable or disable SNMP management for the switch, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 60.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 20.
Figure 20. SNMP Configuration Menu
3. From the SNMP Configuration menu, type 1 to toggle the SNMP Status
option between its two settings of Enabled and Disabled. When set to
Disabled, the default, you cannot manage the switch using SNMP.
When set to Enabled, you can manage the switch using SNMP.
A change to the SNMP status is immediately activated on the switch.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Allied Telesyn AT-9424Ts - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
SNMP Configuration
1 - SNMP Status ........................ Disabled
2 - Authentication Failure Trap Status ..Disabled
3 - Configure SNMPv1 & SNMPv2c Community
4 - Display SNMPv1 & SNMPv2c Community
5 - Configure SNMPv3 Table
6 - Display SNMPv3 Table
R - Return to Previous Menu
Enter your selection?