Allied Telesis AT-S63 - Manual (Page 631)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: Virtual LANs 631
4. Type E to enable GVRP or D to disable GVRP. The default setting is
disabled.
5. Type 2 to select GVRP GIP Status.
The following prompt is displayed:
Enter your new value (E-Enabled, D-Disabled):
6. Type E to enable GIP or D to disable GIP.
Note
Do not disable GIP if you intend to use GVRP. GIP is required to
propagate VLAN information among the ports of the switch.
Caution
The following steps change the three GVRP timers. Please note that
the settings for these timers must be the same on all GVRP-active
network devices.
7. Type 3 to select GVRP Join Timer.
The following prompt is displayed:
Enter new value (in centi seconds): [10 to 60] -> 20
8. Enter a new value for the Join Timer field in centi seconds which are
one hundredths of a second. The default is 20 centiseconds.
If you change this field, it must be in relation to the GVRP Leave Timer
according to the following equation:
Join Timer <= (2 x (GVRP Leave Timer))
9. Type 4 to select GVRP Leave Timer.
The following prompt is displayed:
Enter new value (in centi seconds): [30 to 180] -> 60
10. Type 5 to select GVRP Leave All Timer. The default is 60
centiseconds.
The following prompt is displayed:
Enter new value (in centi seconds): [500 to 3000] -> 1000
11. Enter a value in centiseconds. The default is 1000 centiseconds.
12. To permanently save your changes, return to the Main Menu and type
S to select Save Configuration Changes.