Allied Telesis AT-S63 - Manual (Page 223)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 223
interface is assigned the same address. If the unit obtained its IP
configuration from a DHCP or BOOTP server, the interface is created
with its DHCP or BOOTP client activated. The interface is given the
interface number 0 and assigned to the preexisting management
VLAN. Furthermore, the interface is designated as the local interface
on the switch.
For example, if the switch has the static IP address 149.44.44.44 and
the management VLAN has a VID of 12, the upgrade process
automatically creates a routing interface with the same IP address and
names it VLAN12-0. It assigns the interface to the VLAN with the VID
of 12 and designates it as the switch’s local interface. For information
on routing interfaces, refer to the latest version of the AT-S63
Management Software Command Line Interface User’s Guide.
ˆ The AT-S63 image file also contains the bootloader for the switch. You
cannot load the image file and bootloader separately.
The following guidelines apply to an Xmodem download:
ˆ Xmodem can only download the image file onto the switch where you
started the local management session. You cannot use Xmodem to
download a new image file to a switch accessed through enhanced
stacking.
ˆ The new AT-S63 image file must be stored on the computer or terminal
connected to the RS232 terminal port on the switch.
The following guidelines apply to a TFTP download:
ˆ The switch must have a routing interface on the local subnet from
where it reaches the TFTP server. The switch uses the IP address of
the interface as its source address when sending packets to the TFTP
server. This rule applies to both master and slave switches. If the
switch does not have any interfaces, you can perform the download
from a local management session of the switch using Xmodem or,
alternatively, switch to switch, as explained in “Uploading the AT-S63
Image File Switch to Switch” on page 230.
ˆ Your network must have a node with TFTP server software.
ˆ You must store the new AT-S63 image file on the server.
ˆ You should start the TFTP server software before you begin the
download procedure.
The following procedures assume that you have already obtained the new
software from Allied Telesyn and stored it on the management station from
which you will be performing the procedure, or on the TFTP server.