Allied Telesis AT-S63 - Manual (Page 488)

Chapter 21: SNMPv3
488 Section IV: SNMPv3
When you modify the Security Name parameter, you must use a value that
you configured with the User Name parameter in the Configure SNMPv3
User Table menu. If you do not use a value configured with the User
Name parameter, messages are not sent on behalf of this User Name.
See “Creating an SNMPv3 User Table Entry” on page 420.
To modify the Security Name parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 420. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 140 on page
421.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table menu is shown in
Figure 153.
3. From the Configure SNMPv3 Target Parameters Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is shown in
Figure 154.
Figure 154. Modify SNMPv3 Target Parameters Table Menu
Allied Telesyn AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify SNMPv3 Target Parameters Table
Target Parameters Name ... host27
Message Processing Model . v3
Security Model............ v3
Security Name ............ hoa
Security Level ........... AuthNoPriv
Storage Type ............. NonVolatile
Row Status ............... Active
1 - Set Security Name
2 - Set Security Model
3 - Set Security Level
4 - Set Message Processing Model
5 - Set Storage Type
U - Update Display
R - Return to Previous Menu
Enter your selection?