Allied Telesis AT-S63 - Manual (Page 491)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 491
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 140 on page
421.
2. From the Configure SNMPv3 Table menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table menu is shown in
Figure 153.
3. From the Configure SNMPv3 Target Parameters Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table menu is shown in
Figure 154 on page 488.
4. To modify the Security Level, type 3 to select Set Security Level.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32 alphanumeric characters.
The following prompt is displayed:
Enter Security Level [N-NoAuthNoPriv, A-AuthNoPriv,
P-AuthPriv]:
6. Enter the Security Level.
Select one of the following Security Levels:
Note
The value you configure for the Security Level must match the value
configured for the User Name in the Configure SNMPv3 User Table
menu. See “Creating an SNMPv3 User Table Entry” on page 420.
N-NoAuthNoPriv
This option represents no authentication and no privacy protocol.
Select this security level if you do not want to authenticate SNMP
entities and you do not want to encrypt messages using a privacy
protocol. This security level provides the least security.
Note
If you have selected SNMPv1 or SNMPv2c, N-NoAuthNoPriv is the
only security level you can select.