Allied Telesis AT-S63 - Manual (Page 471)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 471
The following prompt is displayed:
Enter Timeout (10mS): [0 to 2147483647]-> 1500
7. Enter a timeout value in milliseconds.
When an Inform message is generated, a response from the switch is
required. The timeout value determines how long the switch considers
the Inform message an active message. This parameter applies to
Inform messages only. The range is from 0 to 2,147,483,647
milliseconds. The default value is 1500 milliseconds.
The following prompt is displayed:
Enter Retries:[0 to 255]-> 3
8. Enter the number of times the switch will retry, or resend, an Inform
message.
When an Inform message is generated, a response from the switch is
required. This parameter determines how many times the switch
resends an Inform message. The Retries parameter applies to Inform
messages only. The range is 0 to 255 retries. The default is 3 retries.
The following prompt is displayed:
Enter Tag List:
9. Enter a Tag List.
This list consists of a tag or list of tags you configured in a Configure
SNMPv3 Notify Table entry with the Notify Tag parameter. See
“Creating an SNMPv3 Notify Table Entry” on page 462. Enter a Tag
List of up to 256 alphanumeric characters. Use a space to separate
entries, for example:
hwengtag swengtag testengtag
The following prompt is displayed:
Enter Target Parameters:
10. Enter a Target Parameters name.
This name can consist of up to 32 alphanumeric characters. The value
configured here must match the value configured with the Target
Parameters Name parameter in the Configure SNMPv3 Target
Parameters Table.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
11. Select one of the following storage types for this table entry: