Configuring stp, Configuring stp bridge settings – Allied Telesis AT-S63 User Manual
Page 527
AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols
527
Configuring STP
This section contains the following procedures:
”Configuring STP Bridge Settings”, next
“Configuring STP Port Settings” on page 530
“Displaying STP Port Settings” on page 531
“Resetting STP to the Default Settings” on page 533
Configuring STP
Bridge Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
To configure the bridge settings, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 525.