Allied Telesis AT-S63 - Manual (Page 576)

Chapter 23: Multiple Spanning Tree Protocol
576 Section V: Spanning Tree Protocols
Configuring
MSTI-specific
Port Parameters
This procedure explains how to set a port’s priority and internal path cost.
These parameters can be set independently on a port for each MSTI in
which a port is a member. To configure the parameters, perform the
following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 525.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 187 on page 558.
3. From the MSTP menu, type P to select MSTP Port Parameters.
The MSTP Port Parameters menu is shown in Figure 191 on page
574.
4. Type 2 to select Configure Per Spanning Tree Port Settings.
The following prompt is displayed:
Enter Spanning Tree (CIST/MSTI) List :
5. Enter the ID number of the CIST or MSTI where the VLAN containing
the port whose settings you want to configure has been assigned. You
can specify more than one ID number.
The following prompt is displayed:
Start port to configure: [1 to 26] -> 1
6. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
End port to configure: [1 to 26] -> 1
7. Enter the last port of the range. To configure just one port, enter the
same port here as in Step 6.