Allied Telesis AT-S63 - Manual (Page 722)

Chapter 31: 802.1x Port-based Network Access Control
722 Section VIII: Port Security
IEEE 802.1x Port-based Network Access Control Overview
The AT-S63 management software offers you several different methods
for protecting your network and its resources from unauthorized access.
For instance, Chapter 30, “MAC Address-based Port Security” on page
711, explains how you can restrict network access using the MAC
addresses that belong to the end nodes of your network.
This chapter explains yet another way. This method, referred to as 802.1x
port-based network access control, uses the RADIUS protocol to control
who can send traffic through and receive traffic from a switch port. The
switch does not allow an end node to send or receive traffic through a port
until the user of the node has by authenticated by a RADIUS server.
The benefit of this type of network security is obvious. You can use it to
prevent unauthorized individuals from connecting a computer to a switch
port or using an unattended workstation to access your network
resources. Only those users whom you have designated as valid network
users on the RADIUS server will be permitted to use the switch to access
the network.
This port security method uses the RADIUS authentication protocol. The
AT-S63 management software is shipped with RADIUS client software. If
you have already read Chapter 36, “TACACS+ and RADIUS Protocols” on
page 833, then you know that you can use the RADIUS client software on
the switch, along with a RADIUS server on your network, to also create
new manager accounts that control who can manage and change the
AT-S63 parameter on the switch.
Note
RADIUS with Extensible Authentication Protocol (EAP) extensions
is the only supported authentication protocol for 802.1x Port-based
Network Access Control. This feature is not supported with the
TACACS+ authentication protocol. The switch supports only one
authentication protocol at a time. Consequently, if you want to
implement 802.1 Port-based Network Access Control and also
create new manager accounts as explained in Chapter 36,
“TACACS+ and RADIUS Protocols” on page 833, you must use the
RADIUS protocol.
Following are several terms to keep in mind when you use this feature.
ˆ Supplicant - A supplicant is an end user or end node that wants to
access the network through a switch port. A supplicant is also referred
to as a client.