Allied Telesis AT-S63 - Manual (Page 462)

Chapter 21: SNMPv3
462 Section IV: SNMPv3
Configuring the SNMPv3 Notify Table
This section contains a description of the SNMPv3 Notify Table menu and
how to create, delete, and modify table entries. The Configure SNMPv3
Notify Table menu allows you to define a name for sending traps. For each
Notify Name, you define if a trap or inform message ia sent. The two
message types, trap and inform, have different packet formats.
For each Notify group, you can configure:
ˆ Notify Name
ˆ Notify Tag
ˆ Notify Type
ˆ Storage Type
The value of the Notify Tag is linked with the Tag List parameter in the
Configure SNMPv3 Target Address Table menu. As a result, the Notify
Tag parameter assigns a Target IP address to the Notify Table internally.
There are three functions you can perform with the Configure SNMPv3
Notify Table menu.
ˆ “Creating an SNMPv3 Notify Table Entry,” next
ˆ “Deleting an SNMPv3 Notify Table Entry” on page 464
ˆ “Modifying an SNMPv3 Notify Table Entry” on page 465
Creating an
SNMPv3 Notify
Table Entry
To create an entry in the SNMPv3 Notify Table menu, perform the
following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 420. Or, from the Main menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 140 on page
421.
2. From the Configure SNMPv3 Table menu, type 6 to select Configure
SNMPv3 Notify Table.