Allied Telesis AT-S63 - Manual (Page 499)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 499
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 Community Table entry takes effect
immediately.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3
Community
Table Entry
You may want to delete an entry from the SNMPv3 Community Table.
When you delete an entry in the SNMPv3 Community Table, there is no
way to undelete or recover the entry.
To delete an entry in the SNMPv3 Community Table, perform the following
procedure:
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 420. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 141 on page
421.
2. From the Configure SNMPv3 Table menu, type 9 to select Configure
SNMPv3 Community Table.
The Configure SNMPv3 Community Table menu is shown in Figure
155 on page 497.
3. To delete an entry in the SNMPv3 Community Table, type 2 to select
Delete SNMPv3 Table Entry.
The following prompt is displayed:
Enter Community Index:
4. Enter the Community Index that you want to delete.
The following prompt is displayed:
Do you want to delete this table entry?(Y/N):[Yes/No]->
5. Choose one of the following:
Y
Type Y to delete an SNMPv3 Community table entry.
N
Type N to retain the SNMPv3 Community table entry.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.