Allied Telesis AT-S63 - Manual (Page 78)

Chapter 3: Basic Switch Parameters
78 Section I: Basic Operations
Returning the AT-S63 Management Software to the Factory Default
Values
The procedure in this section returns all AT-S63 management software
parameters to the default values. Please note the following before you
perform this procedure:
ˆ Returning all parameter settings to their default values also deletes all
routing interfaces as well as all port-based and tagged VLANs on the
switch.
ˆ This procedure does not delete files from the AT-S63 file system. To
delete files, refer to Chapter 10, ”File System” on page 195.
ˆ This procedure does not delete any encryption keys stored in the key
database. To delete encryption keys, refer to “Deleting an Encryption
Key” on page 779.
ˆ Returning a switch to its default values does not alter the contents of
the active boot configuration file. To reset the file back to the default
settings, you must reestablish your management session after the
switch reboots and then select Save Configuration changes.
Otherwise the switch reverts back to the previous configuration the
next time you reset the switch.
Note
The AT-S63 management software default values are listed in
Appendix A, “AT-S63 Management Software Default Settings” on
page 863.
To return the AT-S63 management software to the default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 60.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 71.
3. From the System Utilities menu, type 4 to select Reset to Factory
Defaults.
The following prompt is displayed:
This operation requires a switch reboot? [Yes/No] ->
4. Type Y for yes or N to cancel the procedure.