Allied Telesis AT-S63 - Manual (Page 47)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 47
3. Configure the terminal or terminal emulation program as follows:
ˆ Baud rate: 9600 bps (The baud rate of the Terminal Port is
adjustable from 9600 to 115200 bps. The default is 9600 bps. For
instructions on changing the baud rate, refer to “Setting the Baud
Rate of the Serial Terminal Port” on page 76.)
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter.
You are prompted for a user name and password.
5. Enter a user name and password. The switch comes with two standard
user accounts: manager and operator. The manager account lets you
configure the switch’s settings while the operator account only lets you
view them.
To log in as the manager, enter “manager” as the user name. The
default password for manager access is “friend. “To log in as an
operator, enter “operator” as the user name. The default password for
operator access is “operator.” User names and passwords are case
sensitive. For instructions on how to change a password, refer to
“Changing the Manager and Operator Passwords” on page 63. For
instructions on how to create your own manager and operator
accounts, refer to Chapter 36, “TACACS+ and RADIUS Protocols” on
page 833.
Note
A switch can support one manager session and eight operator
sessions simultaneously.
6. The local management session starts and the command line interface
(CLI) prompt is displayed, as shown in Figure 2.
Figure 2. CLI Prompt
Allied Telesyn AT-9424T/GB - AT-S63
<No System Name>
#