Allied Telesis AT-S63 - Manual (Page 573)

AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols 573
Configuring MSTP Port Settings
As explained in “Ports in Multiple MSTIs” on page 548, MSTP port settings
are divided into two groups. The parameters in the first group are set just
once on a port, regardless of the number of MSTIs in which a port is a
member. These settings are:
ˆ External path cost
ˆ Point-to-point designation
ˆ Edge port designation
The procedure for setting these parameters is in “Configuring Generic
MSTP Port Settings” on page 573.
The second group of port parameters can be set independently for each
MSTI in which the port is a member. These parameters are:
ˆ Internal path cost
ˆ Priority
To set these parameters, refer to “Configuring MSTI-specific Port
Parameters” on page 576.
Configuring
Generic MSTP
Port Settings
To configure the external path cost of a port or to designate whether the
port is an edge or point-to-point port, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 170 on
page 525.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The MSTP menu is shown in Figure 187 on page 558.
3. From the MSTP menu, type P to select MSTP Port Parameters.