Allied Telesis AT-S63 - Manual (Page 443)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: SNMPv3 443
N-NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Access Table to the configuration file. After making changes
to an SNMPv3 Access Table entry with a NonVolatile storage type, the
S - Save Configuration Changes option appears on the Main Menu,
allowing you to save your changes. Allied Telesyn recommends this
storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 Access Table entry will take effect
immediately.
11. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Access
Table Entry
You may want to delete an entry from the SNMPv3 Access Table. After
you delete an SNMPv3 Access Table, there is no way to undelete, or
recover, the entry.
To delete an entry in the SNMPv3 Access Table, perform the following
procedure:
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 420. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 140 on page
421.
2. From the Configure SNMPv3 Table menu, type 4 to select Configure
SNMPv3 Access Table.
The SNMPv3 Access Table is shown in Figure 145 on page 440.
Note
To display a particular Group Name and its associated parameters
from the Configure SNMPv3 Access Table menu, type N to display
the Next Page and P to display the previous page.
3. From the SNMPv3 Access Table, type 2 to select Delete SNMPv3
Table Entry.
The following prompt is displayed:
Enter Group Name:
4. Enter the Group Name that you want to delete.