Enabling or disabling gvrp on a port, Figure 212: gvrp port parameters menu – Allied Telesis AT-S63 User Manual

Page 632

Advertising
background image

Chapter 25: GARP VLAN Registration Protocol

632

Section VI: Virtual LANs

Enabling or Disabling GVRP on a Port

This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.

Note

Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This
protects against unauthorized access to restricted areas of your
network. For further information, refer to “GVRP and Network
Security” on page 625.

To enable or disable GVRP on a port, perform the following procedure:

1. From the Main Menu, type 2 to select VLAN Configuration.

The VLAN Configuration menu is shown in Figure 199 on page 600.

2. From the VLAN Configuration menu, type 6 to select Configure GARP-

GVRP.

The GARP-GVRP menu is shown in Figure 211 on page 630.

3. From the GARP-GVRP menu, type P to select GVRP Port

Parameters.

The GVRP Port Parameters menu is shown in Figure 212.

Figure 212. GVRP Port Parameters Menu

4. From the GVRP Port Parameters menu, type 1 to select Configure

GVRP Port Settings.

Allied Telesyn AT-9424T/SP - AT-S63

Marketing

User: Manager

11:20:02 02-Mar-2005

GVRP Port Parameters

1 - Configure GVRP Port Settings
2 - Display GVRP Port Configuration

R - Return to Previous Menu

Enter your selection?

Advertising