Allied Telesis AT-S63 - Manual (Page 35)

AT-S63 Management Software Menus Interface User’s Guide
35
Version 1.2.0 Table 4 lists the new features in version 1.2.0.
Table 4. New Features in AT-S63 Version 1.2.0
Feature Change Chapter
MAC Address Table Added the following new
parameters to the CLI commands
for displaying and deleting specific
types of MAC addresses in the
MAC address table:
ˆ STATIC, STATICUNICAST,
and, STATICMULTICAST for
displaying and deleting static
unicast and multicast MAC
addresses.
ˆ DYNAMIC,
DYNAMICUNICAST, and,
DYNAMICMULTICAST for
displaying and deleting
dynamic unicast and multicast
MAC addresses.
Though the menus interface
allows you to display MAC
addresses, as explained in
Chapter 7, “MAC Address Table”
on page 143, it does not support
the new parameters. The new
parameters are only supported in
the command line interface.
Quality of Service Added the following new
parameters to QoS flow groups,
traffic classes, and policies:
ˆ ToS parameter for replacing
the Type of Service field of
IPv4 packets.
ˆ Move ToS to Priority
parameter for replacing the
value in the 802.1p priority
field with the value in the ToS
priority field in IPv4 packets.
ˆ Move Priority to ToS
parameter for replacing the
value in the ToS priority field
with the 802.1p priority field in
IPv4 packets.
ˆ Send to Mirror Port parameter
for copying traffic to a
destination mirror port (policies
only)
Chapter 16, “Quality of Service” on
page 325
Modified procedures:
ˆ “Creating a Flow Group” on
page 341
ˆ “Modifying a Flow Group” on
page 344
ˆ “Creating a Traffic Class” on
page 350
ˆ “Modifying a Traffic Class” on
page 354
ˆ “Creating a Policy” on
page 360
ˆ “Modifying a Policy” on
page 363
MLD Snooping New feature. Chapter 19, “MLD Snooping” on
page 393