Allied Telesis AT-S63 - Manual (Page 113)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 113
The menu options are described below:
1 - Add Attributes to Community
If a community string has a closed access mode, you can use this
selection to add new IP addresses of management workstations that
can use the string. You can also use this option to add IP addresses of
new trap receivers. To use this option, do the following:
a. From the Modify SNMP Community menu, type 1 to select Add
Attributes to Community. The following prompt is displayed:
Enter SNMP Community Name:
b. Enter the community string you want to modify. Community strings
are case sensitive. This prompt is displayed:
Enter SNMP Manager IP Addr:
c. If you are modifying a community string with a closed access mode
and you want to add an IP address of a management workstation
to it, enter the workstation’s IP address at the prompt. Otherwise,
just press Return. A community string can have a maximum of
eight IP addresses, but you can add only one at a time with this
procedure. This prompt is displayed:
Enter Trap Receiver IP Addr:
d. If you want the switch to send traps to a trap receiver, enter the IP
address of the receiver at this prompt. Otherwise, just press
Return.
The community string is modified and the Modify SNMP
Configuration menu is displayed again.
e. Repeat this procedure to modify other community strings.
f. After making changes, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
2 - Delete Attributes from Community
Use this option to delete an IP address of a management workstation
or a trap receiver from a community string. To use this option, do the
following:
a. From the Modify SNMP Community menu, type 2 to select Delete
Attributes from Community. The following prompt is displayed:
Enter SNMP Community Name:
b. Enter the community string you want to modify. Community strings
are case sensitive. This prompt is displayed: