Allied Telesis AT-S63 - Manual (Page 271)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 271
5. Enter the number of the log output that you want to modify.
The Syslog Output Configuration menu is displayed, as shown in
Figure 74 on page 266.
6. Refer to “Creating a Log Output Definition” on page 265 for information
about the menu selections.
7. When you complete the modifications, type M to select Modify Log
Output.
The Configure Log Outputs menu as shown in Figure 73 on page 265
is redisplayed.
8. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.
Deleting a Log
Output
To delete a log output definition, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 69 on page 253.
3. From the Event Log menu, type L to select Configure Log Outputs.
The Configure Log Outputs menu is shown in Figure 73 on page 265.
4. From the Configure Log Outputs menu, type 3 to select Modify Log
Output.
The following prompt is displayed:
Enter output ID to delete [2 to 20] ->
5. Enter the number of the log output that you want to delete.
The following prompt is displayed:
Are you sure you want to delete output ID x? [Yes/No] ->
6. Enter Y for Yes or N for No and press Enter.
If you enter Y, the output ID you selected is deleted.
7. To permanently save your change, return to the Main Menu and type S
to select Save Configuration Changes.