CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 104)

86
1.11.1 Mapping PTZ Cameras
This option assigns a PTZ camera to its corresponding camera channel for either the local or the
remote applications. You must first make sure PTZ Device Setup in the PTZ Control section of the
System Configure dialog box is selected.
z For local applications, see Auto Switching PTZ Control Panels and PTZ Automation later.
z For remote applications, this option will let you control PTZ cameras through the WebCam or
Center V2 server.
1. Click the Configure button (No.14, Figure 1-2), point to Accessories, select PTZ Device and
select Camera Mapping PTZ Dome. This dialog box appears.
Figure 1-71 Camera Mapping Setup
2. Select a camera channel from the Camera drop-down list.
3. Select the PTZ model connected to the selected channel from the Device drop-down list.
4. If you have two identical PTZ cameras set in the system, you may use the Address drop-down list
to choose the one with the correct address. Up to 64 addresses can be supported.
5. For the PTZ Inactivity settings, see PTZ Idle Protection later.
6. Click OK to apply the settings.