CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System User Manual
Page 638
620
7. To create connection to other GV-GIS stations, double-click # 2 to # 4 columns on the GV-GIS
Client window and configure the connection information by following above steps.
8. To start connecting to GV-GIS, click the
button. The GPS data of GV-System will be sent to
GV-GIS.
Sending GPS Data of both GV-System and Connected IP Devices
You can not only send the GPS data of GV-System to the GV-GIS station, but also those of connected
IP devices. On the GV-GIS station, the Mobile Host accounts for GV-System and IP devices need to
be created individually in advance.
1. To allow the remote access from GV-GIS to GV-System, enable Control Center Server from the
Network button on the main screen.
2. Ensure
Enable GIS Data is enabled for desired IP devices to receive the GPS data from those IP
devices (Figure 11-95).
3. Click
the button on the GV-GIS Client window (Figure 11-93). This dialog box appears.
Figure 11-99
4. In the GPS Data Source Selection section, select IP Device.
5. In the Connection Information section, type the IP address of GV-GIS. Keep the default port value
of 3356, or modify it if necessary.