CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System User Manual
Page 111
Configuring Main System
93
1
1. Click
the
Configure button (No. 14, Figure 1-2), point to System Configure, and select Camera
Configure. A dialog box appears.
2. To set the recording mode to motion detection, enable Rec Video, and select Motion Detect from
the drop-down list.
3. To enable noise tolerance, click the right-arrow button next to Motion Sensitivity in the Motion
Detect section. The Motion Detection Setup dialog box appears.
4. Select
Activate Noise Tolerance and adjust tolerance level. The higher the level, the more
tolerant the system is to video noise. If your surveillance area may produce much video noise, set
the level to High. Conversely, set the level to Low if the surveillance area may produce less video
noise.
5. Click
OK to save the settings.
Setting Up for Advanced Motion Detection
For details, see Advanced Motion Detection in chapter 3.