CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 317)

I /O Applications
299
6
6.3.2 Moving PTZ Camera to a Preset Location upon Input
Trigger
This feature allows you to define how the PTZ camera and the GV-System will respond to an input
trigger event.
Figure 6-9
Select an Input number to be set up. Clicking the Finger button can apply the same settings to all
inputs.
„ Preset Go by I/O: Enable the option and select your PTZ camera from the drop-down list.
„ Addr: Specify the address of the PTZ camera.
„ Alarm On: Turns the PTZ camera to a preset point when the input is triggered.
„ Alarm Off: Returns the PTZ camera to a preset point when the triggered input is off.
„ Alarm On Dwell Time: Specify the amount of time the PTZ camera stays at “Alarm On” preset
point, before returning to the “Alarm Off” preset point.
Note: Depending on the capability of the PTZ camera, up to 256 PTZ preset points (ranging from 1 to
256) and addresses (ranging from 0 to 255) can be programmed.