CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 650)

632
11.19.4 Setting Individual Cameras
Follow the steps below to enable and set up individual cameras. When the camera view is being
transmitted to a client, two streams are available to choose from. You can set up different settings for
stream 1 and stream 2, such as frame rate, codec and resolution.
1. In the left menu, click a camera channel. The setting page for that camera appears.
Figure 11-107
2. Select Enable to enable the camera.
3. Under Stream Setting, the following settings are available. When a client connects to stream 1 of
the camera, the settings will be applied to the transmitted camera view.
„ FPS: Specifies the frames per second.
„ Quality: Set the image quality to Best, Better or General.
„ Codec: Select a codec type.
„ Resolution: Select a resolution. When Maximum is selected, the resolution will be D1. If the
camera’s maximum resolution is lower than D1, the maximum resolution will be applied.
4. To set up the other stream, click the Stream 2 tab and complete the above settings.
5. Click Apply.
6. In the left menu, right-click a camera channel to access the options below: