CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 628)

610
7. Start monitoring. When motion is detected or the input device is triggered, the live video will pop
up for alert.
Setting Pop-up Positions
When you select Random Position of Camera, you can decide the positions for pop-up cameras.
„ Fixed Position of Camera: The cameras pop up in their assigned positions. To assign positions,
select Screen Division. Then drag and drop the cameras number to the desired potions on the
divisions.
„ Random Position of Camera: The positions of pop-up cameras are based on the sequence order
of triggers. There are two modes for this position:
1. Cascade Mode: This mode can avoid the same cameras popping up on different monitors.
This is suggested to be used when multiple monitors are placed close to each other.
Example:
Camera 1, Camera 2, Camera 3, Camera 4 and Camera 5 are assigned for alert popup on
both Monitor 1 and Monitor 2. Monitor 1 is set at 4 screen divisions. When the five cameras
are triggered at same time, the first 4 cameras show up on Monitor 1 and the 5th on Monitor
2.
2. Parallel Mode: This mode allows the same cameras simultaneously pop up on different
monitors. This is suggested to be used when multiple monitors are placed in separate rooms.
Example:
Camera 1, Camera 2, Camera 3 and Camera 4 are assigned for pop-up upon motion
detection on both Monitor 1 and Monitor 2. When the four cameras are triggered at the same
time, they will show up simultaneously on both Monitor 1 and Monitor 2.
2 1
3 4
5
Monitor 1 Monitor 2
2 1
3 4
2 1
3 4
Monitor 1 Monitor 2