CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 154)

136
9. When the PTZ is tracking, you can still control it to zoom in a desired area. Click the Zoom in
Object item and specify Idle Time (sec). Idle Time (sec) indicates the zooming duration in
seconds. If a target appears after the specified idle time, the PTZ will start tracking. If not, the PTZ
will remain on the zoomed place.
Figure 3-6
10. Click the Schedule button to set a schedule to enable the function. For details, see Video
Analysis Schedule later in this chapter.
11. Click the Test button to check your settings. There are two major settings you have to observe in
the testing. 1) Tracking: Observe if the target showing in the defined detection region is being
tracked with a highlighted mask, and magnified automatically in the left image. If not, increase the
sensitivity degree. 2) Zooming: Use the mouse to outline an object in the right image, and observe
if it is magnified in the left image clearly. If not, use the Live Tuning buttons to adjust directions
and the desired level of zooming.
12. Click OK to save your settings of the tracking time, the idle time for zooming in objects and the
testing results.
Starting Object Tracking
After the above settings, you can start the object tracking application. Click the Configure button (No.
14, Figure 1-2), point to Video Analysis, select Object Tracking Application, and then click Object
Tracking Start to start the function.
Tip: You can interrupt the PTZ camera tracking and take over the camera control by using PTZ
Control Panel on Main System, PC’s keyboard and GV accessories such as GV-Keyboard, GV-IR
Remote Control, and GV-Joystick. When the controlling device or panel is inactive for over 5
seconds, the PTZ camera will go back for tracking.