CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 42)

24
1.2.6 Customizing Startup Settings
The Startup dialog box allows you to set the system to enable selected features at system startup. To
access the Startup dialog box, click the Configure button (No.14, Figure 1-2), select System
Configure and click Startup.
Figure 1-15
[General]
„ Start Monitor: Select one of the following monitor control modes at system startup:
~ Monitor All: Allows you to monitor all cameras and I/O (if available) at system startup. It is the
same as to manually click Monitor button (No. 16, Figure 1-2) and select Start All Monitoring.
(For details, see Camera Monitoring later in this chapter).
~ Schedule Monitor: Allows you to monitor cameras by schedule. Alternatively you may click
Schedule button (No. 15, Figure 1-2) and select Schedule Start. Refer to Recording
Schedule later in this chapter.
~ I/O Monitor: Allows you to monitor all I/O devices. Alternatively you may click the Monitor
button (No. 16, Figure 1-2), and then select I/O Monitoring.
~ Camera Monitor: Enables all cameras for monitoring.
Note: To set different recording modes and alert methods for each camera, see Monitor Control in
Adjusting Individual Camera later in this chapter.