Metrohm 833 IC Liquid Handling Unit - Manual (Page 45)

6.1 Connection to modular IC system for neutralization
833 IC Liquid Handling Unit / Instructions for Use 8.833.1003
37
The electrical connections of this system to the 766 IC Sample
Processor with complete control by the «IC Net 2.3» software is
described below.
6.1.1 Electrical connections
The electrical connections of the system, consisting of 819 IC Detector,
820 IC Separation Center (2-channel; 2.820.0X20), 818 IC Pump, 833 IC
Liquid Handling Pump Unit (2.833.0010), 833 IC Liquid Handling
Suppressor Unit (2.833.0020), 833 IC Liquid Handling Sample
Preparation Unit (2.833.0030) and 830 IC Interface are shown in Fig. 12:
Fig. 12: Electrical connections for 833 IC Liquid Handling Sample
Preparation Unit and modular IC system for neutralization
Please note that the signal for switching the connected 833 IC Liquid
Handling Suppressor Unit to the next position is not controlled by the
program of the 766 Sample Changer. Instead the remote connection 14
of the 833 IC Liquid Handling Suppressor Unit for the
Suppressor/Actuator is connected by 6.2128.180 cable with the event
line “Fill” of valve B (sample loop before the sample preparation
module) to the 820. In this way a move to the next position of the
suppressor is triggered by the “Fill” setting of this valve.
830
833 Suppressor
833 Sample Prep
833 Pump
820
818
819
PC
6.2134.100
6.2134.080
6.2134.090
6.2134.130
6.2143.210
6.2115.070
6.2125.120
6.2125.090
6.2141.110
6.2143.200
6.2128.180
6.2128.180
6.2128.180
766
B (LOOP) A (PCC)
6.2134.040