ADS Environmental Services FlowShark QR 775002 A4 User Manual
Page 102
Communication
4-21
Hole running from antenna installation location to manhole
8. Thoroughly clean out the hole for the antenna of all debris
using a shop vacuum with a brush.
9. If the protective cap is not present on the connector at the end
of the antenna cable, clean the connector and tape it up with
rubber stretch tape to protect it from damage and debris while it
is traveling through the channel.
10. Feed the antenna cable into the hole, through the channel, and
into the manhole until the antenna is seated firmly inside the
hole in the road. Be careful not to crimp or crush the cable.
11. Holding the antenna in place, drill through the holes in the
corners of the antenna into the ground the entire depth of the
drill bit.
12. Pull the antenna out of the hole, vacuum out the dust from
inside the screw holes, and clean the antenna with an alcohol
wipe. Let the antenna air dry.
13. Put on protective latex gloves.