ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 142)

6-16 ADS FlowShark Manual
Editing the Velocity Device
Edit the velocity device in the following way, and select OK when
complete:
Edit Velocity Device Properties dialog
Note: Typically, the velocity device should not require
editing. However, when editing is necessary, ADS does not
recommend changing velocity parameters without proper
training or assistance.
 Use Defaults Select this checkbox to apply the default
parameters to the velocity device. Deselect this option to enable
the fields to allow editing of the velocity device parameters.
 Sensitivity Select the appropriate velocity sensor sensitivity
from the drop-down. A sensitivity that is too high may produce
noise, causing interference in the signal and resulting in spikes
in the data. A low sensitivity can produce readings that are low
in comparison with confirmation readings.
 Velocity Direction Select the direction in which the flow
occurs or the velocity sensor is positioned.