ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 89)

4-8 ADS FlowShark Manual
Note: The wire colors referenced in this manual are based
on the telephone cable recommended for use in these
applications. However, the wires inside some telephone
cables may vary in color and number. Therefore, when the
actual wire colors and number differ from those designated
in this manual, connect the available wiring in reference to
ground, ring, and tip.
5. At the pedestal end of the cable, fold over both exposed wires
(doubling the thickness). Insert each wire into a non-insulated
#10 ring terminal lug (22-18 gauge), and crimp the wires to the
lugs.
Wiring the Telephone Cable to the Monitor
After preparing the telephone cable, wire the telephone cable to the
monitor as follows:
1. Identify the communications port (COMM) on top of the
monitor.
COMM (communications) port on top of the monitor
2. Seat and secure the mating telephone cable connector onto the
communications port (COMM).