Assembling the ring – ADS Environmental Services FlowShark QR 775002 A4 User Manual
Page 43
Sensor Installation and Connection 3-9
Assembling the Ring
The flow sensors mount to a stainless steel ring that is installed in
the pipe. Several different ring sizes exist, and each ring is
adjustable within about 3 inches to fit pipes of different diameters.
Assemble the ring in the following way:
Note: These instructions generally apply to overlapping
rings. However, the 6-, 8-, 10-, and 12-inch rings do not
have an overlapping section. Therefore, these non-
overlapping rings will require small modifications to the
assembly process. To assemble a non-overlapping ring,
proceed directly to step 4.
1. Insert the spreader mechanism screw through the hole in the
center of the ring stabilizer. Ensure that the head of the screw
fits into the countersunk hole.
Ring stabilizer with spreader mechanism screw
2. Slide the open end of the ring (end without the welded metal
band) through the flanges in the ring stabilizer, making sure the
flanges face the outside of the ring and the spreader mechanism
screw faces the inside of the ring.