ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 127)

6-1
C H A P T E R 6
Configuration and Activation
After installing the FlowShark ® monitor and sensors and setting up
communication, it is necessary to configure and activate the monitor
to begin taking flow measurements and recording data at the
monitor location. This chapter contains general instructions on the
following activities concerning monitor configuration and
activation:
 Creating a monitor location
 Creating an installation (pipe) table
 Selecting and editing devices
 Setting the communication parameters
 Activating the monitor
This chapter also includes the procedure for running diagnostics on
the sensor devices, collecting data from the monitor, and upgrading
the firmware (embedded software) in the monitor.
Refer to the Profile ® User's Guide (#950015**) for more detailed
instructions on installing the software, collecting monitor data, and
configuring, activating, and confirming the monitor.
Refer to Chapters 8 and 9 of this manual for additional
configuration steps required when setting up FlowShark monitors to
receive analog input signals or send analog output signals or
Modbus ASCII to customer equipment for real-time monitoring.