ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 214)

10-2 ADS FlowShark Manual
Maintaining the System Components
The FlowShark flow monitor and sensors should receive routine on-
site inspections and remote confidence checks to maintain the
equipment in optimal working condition, minimize monitor
downtime, and prevent possible data loss.
ADS recommends performing these inspections following initial
system installation, during site visits, and on a scheduled interval
(i.e., quarterly or during battery pack replacement).
Note: The only service or maintenance activity ADS
permits within the monitor chassis is battery pack
replacement. Therefore, please do not handle, alter,
modify, remove, or replace any other components inside
the monitor. This may void the monitor warranty
agreement.
Gathering Replacement Parts and Supplies
Gather the following replacement parts and supplies for performing
routine maintenance:
 Dryer tube or desiccant for the pressure depth sensor
 Battery packs (replace both at the same time)
 Ultrasonic depth, pressure depth, and Doppler velocity sensors
 Soft bristle brush
 Paper towels
 Compressed air
 Flat head screwdriver and assorted wrenches (including torque
wrench)