ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 123)

5-4 ADS FlowShark Manual
Installation of the ADS Power Supply
The 12VDC power supply is housed in a 5.1" x 5.1" x 5.1" NEMA
4X polycarbonate enclosure suitable for outdoor mounting. Panel
mounting is via four 0.175” holes located under the corner cover
screws.
The power supply comes with a 6‘ long AC power cord, or can
alternatively be powered via user-supplied cabling. A cable grip
fitting is provided to seal the exit of the DC output cabling (cable
grip is sized for 0.125” to 0.375” OD cable). Replace the cable grip
fittings if needed for custom AC supply or DC output wiring.
12VDC power supply
Note: Never drill any holes through the housing for
mounting! This will expose the internals of the enclosure
to moisture and create an unsafe operating condition! It
will also void the product warranty. Only use the mounting
holes provided under the corner cover screws to facilitate
mounting to a panel or other mounting surface.