ADS Environmental Services FlowShark QR 775002 A4 - Manual (Page 150)

6-24 ADS FlowShark Manual
 Low Modem Battery TCP/IP Enter the voltage from
the battery pack powering wireless communications (for
BG monitors with a battery pack dedicated to powering the
wireless modem alone) below which you want Profile to
provide notification. This setting also applies to the voltage
from the battery packs found in monitors equipped with
battery packs that work in parallel to power all monitor
functions, including wireless communications. ADS
recommends leaving the default battery setting unchanged.
 Low Signal Strength TCP/IP Enter the signal strength
(in dBm) below which you want Profile to provide
notification for the wireless communication unit, when
applicable. ADS recommends using -95 dBm for the low
signal strength.
 Low Battery FlowShark Enter the voltage supplied by
one (powering the monitor) or both battery packs
(powering both the monitor and wireless communications),
based on the model, below which you want Profile to
provide notification for FlowShark monitors. The ADS
recommends leaving the default battery voltage
unchanged.
Note: Notification of low battery voltage or signal
strength occurs during the data collection process, during
monitor activation, and when receiving TCP/IP
communication status. View the associated logs through
the Diagnostics tool and Log Viewer in Profile.
 Low Battery FlowShark IS Internal (This parameter
does not apply to the FlowShark monitor.)
 Low Battery FlowShark IS External (This parameter
does not apply to the FlowShark monitor.)
 Low Battery FlowAlert/RainAlert II (This parameter
does not apply to the FlowShark monitor)
 Low Battery Triton/FlowHawk (This parameter does
not apply to the FlowShark monitor)
4. Select the OK button.