Panasonic NVDS5EG User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

DEUTSCH

■ Stromversorgung mit dem Akku

Vor der Auslieferung aus der Fabrik wurde der Akku nur

minimal aufgeladen. Er muß daher vor der
Inbetriebnahme zuerst vollständig aufgeladen werden.

1

2

3

Den Akku waagerecht bis zum
Anschlag auf den Netzadapter
aufschieben.

Das Netzkabel an den Netzadapter und

an eine Netzsteckdose anschließen.

Sobald alle vier Ladeanzeigelampen am
Netzadapter leuchten, ist das Aufladen
beendet.

Zum Abnehmen des Akkus diesen in
entgegengesetzter Richtung zum

Schritt 1 schieben.

• Auch das Netzkabel aus der Netzsteckdose

ziehen.

Den Hebel

[ A

BATTERY] schieben.

Den Akkufachdeckel öffnen.

Den Akku mit der Markierung Q nach
innen gerichtet einsetzen.

Den Akkufachdeckel so schließen, daß

er mit einem Klick verriegelt.

Herausnehmen des Akkus
Den Akkufachdeckel öffnen und den Akku-Auswurfhebel

Q

drücken.

♦ Die Hand über das Akkufach halten, damit der Akku

nicht herausfallen kann.

♦ Vor dem Herausnehmen des Akkus den Schalter

[POWER ON/OFF] auf [OFF] stellen.

Vorsicht

Den Akku mit der Markierung

(A)

ins Innere des

Camerarecorders gerichtet einsetzen, wie oben gezeigt.
Das Einsetzen des Akkus mit nach außen gerichteter
Markierung könnte den Gamerarecorder ernsthaft
beschädigen.

5

6

7

8

ENGLISH

■ Supplying Power with the Battpry

The Battery was only minimally charged before shipping.
Therefore, fully charge it before you use it for the first
time.

1

2

3

4

Place the Battery on the AC Adaptor as

shown above and slide it horizontaliy

until it stops.

Connect the AC Mains Cable to the AC
Adaptor and an AC mains socket.

When all four Charge Lamps are lit,
charging is finished.

Remove the Battery by sliding it in the
opposite direction of Step 1 above.

•Also disconnect the AC Mains Cable.

5

Siide the

[ A

BATTERY] Lever.

6 Open the Battery Compartment Cover.

7

Insert the Battery with O pointing

inside.

8

Close the Battery Compartment Cover

so that it locks with a click.

Removing the Battery
Open the Battery Compartment Cover and push the

Battery Eject Lever ©.

♦ Hold your hand over the Battery Compartment Cover to

prevent the Battery from dropping.

♦ Before removing the Battery, set the [POWER

ON/OFF] Switch to [OFF].

Caution

Be sure to insert the Battery with the [A] mark pointing
into the Movie Camera. If you insert it with the mark
pointing outside, it could damage the Movie Camera.

-18-

Advertising