Clfe, Benutzen des suchers, Benutzen des lcd-monitors – Panasonic NVDS5EG User Manual

Page 26: Using the finder, Using the lcd monitor, Benutzen des suchers benutzen des lcd-monitors, Using the finder using the lcd monitor

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

12Ä3C4S

10.15.1997

12:30:45

10.15.1997

V

J

Clfe

180

DEUTSCH

ENGLISH

Benutzen des Suchers

Ver dem Benutzen des Suchers diesen präzis so auf die
Sehkraft Ihrer Augen abstimmen, daß die Anzeigen im
Sucher klar und deutlich sichtbar sind.

1

Den Schalter [POWER ON/OFF] auf

[ON] stellen.

2

Den Sucher nach hinten schieben.

Der Winkel des Suchers läßt sich nach oben
verstellen. Jedoch unbedingt zuerst den Sucher bis

zum Anschlag nach hinten schieben, bevor Sie ihn

nach oben schwenken.

3

Den Okularkorrekturring O drehen, bis die

Anzeigen im Sucher klar und deutlich sind.

Sie können zudem die Helligkeit des Sucherbildes im
Menü |MENU (OTHERS)] regeln. (-> 120-124,132)

Benutzen des LCD-Monitors

Sie können auch aufnehmen, während Sie das Motiv auf
dem geöffneten LCD-Monitor betrachten.

1 Den Schalter [POWER ON/OFF] auf

[ON] stellen.

^ Den Hebel [PUSH OPEN] schieben und

den LCD-Monitor in Pfeilrichtung um
ca. 90° öffnen.

Der Sucher schaltet automatisch ab.

Einstellen des Winkels

3 Den Winkel des LCD-Monitors dem

gewünschten Aufnahmewinkel

entsprechend einstellen.

♦ Der LGD-Monitor läßt sich aus seiner normalen

senkrechten Stellung um maximal 180° nach oben
0 und 90° nach unten © drehen. Ein gewaltsames

Drehen über diesen Bereich hinaus könnte den
Camerarecorder ernsthaft beschädigen.

• Sie können die Farbsättigung und Helligkeit des

LCD-Monitors im Menü [MENU (OTHERS)] regeln.

{-*

120-124, 132)

Schließen des LCD-Monitors
Den LCD-Monitor gegen das Cameragehäuse schwenken,

bis der Hebel [PUSH OPEN] mit einem Klick einrastet.

Using the Finder

Before using the Finder, adjust it to your eyesight so that
the indications in the Finder are clear and easy to read.

1

Set the [POWER ON/OFF] Switch to

[ON].

2

Slide the Finder backward.

The angle of the Finder can be adjusted upward.

However, be sure to slide it backward until it stops,
before turning the Finder Upward.

3

Adjust by turning the Eyepiece

Corrector Dial o

You can adjust the brightness of the Finder on the

[MENU (OTHERS) ] Menu.

{•*

120-124, 132)

Using the LCD Monitor

It is also possible to record while viewing the picture on

the opened LCD Monitor.

H Set the [POWER ON/OFF] Switch to

[ON].

^ Push the [PUSH OPEN] Lever and turn

out the LCD Monitor approximately 90°
in the direction of the arrow.

The Finder turns off.

Adjusting the Angle

3 Adjust the angle of the LCD Monitor

according to the recording angle

♦ The LCD Monitor rotates upward a maximum of

180° © and downward a maximum of 90° @ from
its normal vertical position. Trying to forcefully
rotate it beyond this range could seriously damage

the Movie Camera.

• You can adjust the colour and brightness of the

LCD Monitor on the [MENU (OTHERS)] Menu.
(-* 120-124,132)

Closing the LCD Monitor

Push the LCD Monitor close until the [PUSH OPEN]
Lever locks with a click.

-26-

Advertising