KERN & SOHN AET 200-4NM - Manual (Page 152)

152 AET_/PET_/ILT_NM-BA-e-1410
Application of outputs:
The set of outputs is used to SIGNAL the status of measurement result.
Change of logic status of the output system, e.g. from [0] to [1] takes place
on meeting a requirement assigned to the output.
Each of 4 outputs is connectable to the following data:
Available options Balance status, which switches the logic of
output
None -------
Stable Each stable measurement switches the logic of
the system
MIN stable Stable measurement below [MIN] threshold
switches the logic of the system,
MIN unstable Unstable measurement below [MIN] threshold
switches the logic of the system,
OK stable Stable measurement within [MIN] [MAX]
thresholds switches the logic of the system,
OK unstable Unstable measurement within [MIN] [MAX]
thresholds switches the logic of the system,
MAX stable Stable measurement below [MAX] threshold
switches the logic of the system,
MAX unstable Unstable measurement below [MAX] threshold
switches the logic of the system
Confirmation of cycle
completion
End of procedure
Procedure
- Press key and press: “ Inputs / Outputs” key.
- Enter submenu < Inputs / Outputs>, select and press < Outputs> key
- Enter editing mode of a selected output, which opens list of available
functions,
- Select a function from displayed list and return to weighing with saving
carried out changes.