Pilz PSSnet SHL 8T MRP - Manual (Page 152)

152
4.6 Device Configuration Commands
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.6.38 show port
This command displays port information.
Format
show port { <slot/port> | all } [name]
Mode
Privileged EXEC and User EXEC
Slot/Port
Valid slot and port number separated by forward slashes.
Name
When the optional command parameter name was specified, the out-
put is different. It specifically includes the Interface Name as the sec-
ond column, followed by other basic settings that are also shown by
the normal command without the command parameter name.
Type
If not blank, this field indicates that this port is a special type of port.
The possible values are:
Mon - this port is a monitoring port. Look at the Port Monitoring
screens to find out more information.
LA Mbr - this port is a member of a Link Aggregation (LAG).
Probe - this port is a probe port.
Admin Mode
Indicates the Port control administration state. The port must be
enabled in order for it to be allowed into the network. - May be
enabled or disabled. The factory default is enabled.
Physical Mode
Indicates the desired port speed and duplex mode. If auto-negotiation
support is selected, then the duplex mode and speed will be set from
the auto-negotiation process. Note that the port's maximum capability
(full duplex -100M) will be advertised. Otherwise, this object will deter-
mine the port's duplex mode and transmission rate. The factory
default is Auto.
Physical Status
Indicates the port speed and duplex mode.
Link Status
Indicates whether the Link is up or down.