Pilz PSSnet SHL 8T MRP - Manual (Page 95)

CLI Commands: Base
PSSnet SHL - Command Line Interface
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
4.4 Management Commands
95
4.4.27 snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The ad-
dress is the associated community SNMP packet sending address and is
used along with the client IP mask value to denote a range of IP addresses
from which SNMP clients may use that community to access the device. A
value of 0.0.0.0 allows access from any IP address. Otherwise, this value is
ANDed with the mask to determine the range of allowed client IP addresses.
The name is the applicable community name.
Default
0.0.0.0
Format
snmp-server community ipaddr <ipaddr> <name>
Mode
Global Config
U no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to
0.0.0.0. The name is the applicable community name.
Format
no snmp-server community ipaddr <name>
Mode
Global Config